Pro-face AGP-3300 Series Guía de instalación descargar pdf (Pagina 12)

12

4. Input/Output Signal Line Cautions

• All GP Input and Output signal lines

must be separated from all operating

circuit (power) cables.

• If this is not possible, use a shielded

cable and ground the shield.

Securing the USB cable con-

nection

• When using USB Host Interface in

Hazardous Locations provided in

UL1604, please fix the USB cable with

the USB Holder. If it’s not fixed so that

the connector on the GP’s side and the

PLC’s side cannot come out, the USB

Host Interface cannot be used in the

Hazardous Locations.

1. GP-3300 Series units (Except for

AGP-3310T/AGP-3360T)

 Attaching the USB Cable Clamp

(1) Insert the USB holder into the slot in

front of the GP unit’s USB port and

pull it down and forward.

(2)

Pass the band of the USB cable clamp

through the bridge of the USB holder.

(3) Insert the USB cable into the port.

Fasten the band around the plug and

secure it with the clamp.

 Removing the USB Cable Clamp

(1) Lower the tab and lift the clamp to

release the plug.

GP unit

Other

Equipment

Common Grounding (OK)

GP unit

Other

Equipment

Common Grounding

(Not OK)

1

2

USB Holder

Bridge

USB Holder

Clamp

USB Cable

Tab

Clamp

1 2 ... 7 8 9 10 11 12 13 14 15 16

Comentarios a estos manuales

Sin comentarios