Pro-face AGP-3300 Series Guía de instalación Pagina 1

1GP-3300/3400 SeriesInstallation GuidePackage Contents(1) GP Unit (1)(2) English and Japanese installation Guides (1 of each) <This Guide>(3) Wa

10Wiring• To avoid an electric shock, prior to connecting the GP unit’s power cord terminals to the power terminal block, confirm that the GP unit’s p

11(4) Attach the Power connector (Plug) to the GP.2. Power Supply Cautions• Input and Output signal lines must be separated from the power control cab

124. Input/Output Signal Line Cautions• All GP Input and Output signal lines must be separated from all operating circuit (power) cables.• If this is

132. AGP-3310T/3360T units• Be careful for the edge of the clip not to cut the fingers. Attaching the USB Cable Clip(1) Mount the clip to the USB mar

14(5) Following the diagram, completely tighten the tie and thoroughly affix the clip on the connector shell.• Attach the GP unit's rear face of

15 Removing the USB Holder(1) Lift up the tab of the USB holder and then remove the USB cover as shown below.(2) After removing the USB cable, remove

16(5) WARNING: Explosion hazard-confirm that the power supply has been turned OFF before disconnecting equipment, or confirm that the location is not

2Part Names and FunctionsName DescriptionAStatus LED(The logic program is disabled in the AGP-3302B/3301L/3301S. The Status LED turns on only in Opera

3• The following is each part for the AGP-3310T/3360T.F USB Host Interface (USB)Complies with USB 1.1. Uses a “TYPE-A” connector.Power supply voltage:

4General Specifications Electrical Specifications Environmental SpecificationsAGP-3300∗/3301∗/3310T/3360TAGP-3302B AGP-3400∗/3450TPower SupplyInput

5External Interfaces• For instructions on how to connect to other devices, always refer to the “GP-Pro EX Device/PLC Connection Manual”.• Always conne

6 COM2• Always connect close to the GP unit's COM port when terminating with the termina-tion pins (TRMRX/TRMTX).Recommended Cable ConnectorXM2

7 AUX Input/Output and Sound Output Interface (Supported by GP-3400 series only)GP Unit Side ConnectorS2L3.5/12/90F <made by Weidmuller>Termina

8Installations1. Installation Requirements• For easier maintenance, operation, and improved ventilation, be sure to install the GP at least 100 mm [3.

9• Tightening the screws with too much force can damage the GP unit’s plastic case.• The necessary torque is 0.5 N•m.3. Wiring and attaching/detaching