Pro-face FP2600-T41 Guía de instalación descargar pdf (Pagina 8)

Attach the Installation Fasteners from Inside the Panel

The following figures show the four(4) fastener insertion slot locations. Insert each fastener's

hook into the slot and tighten it with a screwdriver.

• Tightening the screws with too much force can damage the FP's plas-

tic case.

• The necessary torque is 0.5N•m.

• Depending on the installation panel's thickness, etc., the number of installa-

tion fasteners used may need to be increased to provide the desired level of

moisture resistance.

• If the number of the installation fasteners is increased, do not use the FP side

face's middle installation fastener hole. Instead, use the top and bottom holes.

Insertion Slots

Top

Bottom

• Before installing the FP into a cabinet or panel, check that the installation

gasket is securely attached to the unit.

• A gasket which has been used for a long period of time may have scratches

or dirt on it, and could have lost much of its dust and drip resistance. Be

sure to change the gasket periodically (or when scratches or dirt become

visible).

Confirm the Installation Gasket's Positioning

It is strongly recommended that you use the gasket. It absorbs vibration in addition to repelling

water.

Place the FP on a level surface with the display panel facing downward. Check that the FP’s

installation gasket is seated securely into the gasket’s groove, which runs around the perimeter of

the panel’s frame.

Gasket

Rear face

5 Installation

under 4-R2

Panel

Panel thickness

1.6mm[0.06in] to

10mm[0.39in]

Unit: mm [in]

Create a Panel Cut and insert the FP into the panel from the front

301.5 [11.87 ]

+0.04

227.5

[8.96 ]

+0.04

Panel

Installation fastener

1 2 3 4 5 6 7 8 9 10

Comentarios a estos manuales

Sin comentarios

Pro-face FP2600-T41 Guía de instalación Pagina 8

Comentarios a estos manuales

Relacionado con productos y manuales para Monitores de pantalla táctil Pro-face FP2600-T41